Low-side edge details coordinated with underlayment and panel conditions.
Trim & flashing
Metal roof trim & flashing for clean installs.
Coordinate eave, rake, ridge, valley, wall, transition, and custom-bent trim with the metal roofing package instead of chasing pieces after installation starts.
Job-specific supply
Every bend needs a purpose.
Good trim starts with clear dimensions, the right material, and a drawing everyone can understand.
Trim closes the assembly at the eaves, rakes, ridges, valleys, walls, and transitions. A clean request identifies every condition on the roof and gives each piece enough information to be produced or supplied correctly.
For custom bends, upload a dimensioned drawing or approved sample. Mark each leg, angle, hem, kick, open or closed end, piece length, quantity, material, gauge, and finish.
Perimeter trim for gable ends and finished-edge requirements.
Caps, closures, and ventilation details for the roof system.
Valley metal sized for the roof geometry, water path, and panel system.
Endwall, sidewall, headwall, and pitch-change pieces.
Project-specific shapes from a clear drawing or approved sample.
Material-list check
Put this on the sketch.
Label each leg, angle, hem, kick, and open or closed end.
Include gauge, finish, and the panel system it connects to.
List piece count and finished length for each bend.
Show how the piece sits on the roof and which side faces out.
Contractor FAQ
Before the order is approved.
What details are needed for custom metal roof trim?
Provide a dimensioned drawing or approved sample showing each leg, angle, hem, kick, open or closed end, material, gauge, finish, quantity, and piece length.
Can trim be matched to a standing seam panel order?
Yes. Matching roof trim can be coordinated with a confirmed panel material and finish. Verify the final color against the current manufacturer sample.
Which trim pieces can be included?
Requests may include eave and drip edge, rake and gable trim, ridge and hip cap, valley, endwall and sidewall flashing, transition flashing, and custom bends.
Have a trim sketch?
Upload the drawing with the dimensions, material, finish, quantity, and timing.